WikiPhone:Phone Access:Dial in via SIP
You can access various public WikiPhone services on any SIP client, phone, or PBX (via trunk). This can done in the form of entering a "SIP URI" on your client. For example, you can reach the WikiPhone Updates Hotline at sip:updates@telephones.wiki. Please note that you cannot reach WikiPhone staff members or departments over public SIP. You will need to either use the PSTN or a collectors network. For each service, we provide both an alphabetic and a numeric URI so that if your device does not allow the use of letters, you can still reach each service. Authentication or registration is not required. The standard SIP port (5060) is used for all URIs.
Available Services
| Service | Alphabetic URI | Numeric URI |
|---|---|---|
| WikiPhone Updates Hotline | updates | 0200 |
| Jordan U Ambient Temperature Line | jordanu | 0250 |
| Listen to articles | articles | 0201 |
Available Codecs
Our system will accept the following codecs for SIP calls:
- g711 ulaw
- g711 alaw
- g722 HD
At this time, we do not support other codecs as these codecs are supported by nearly every SIP client; as such, we don't deem it necessary to test and support other codecs.
Dialing URI's
To dial a URI on a SIP client, you will need to enter <uri>@telephones.wiki or if you don't have DNS, <uri>@135.148.32.154 into your SIP client. Example: articles@telephone.wiki or Some clients will require sip: before the URI. Some will also attempt to dial using the active SIP account if you are connected to a SIP server such as a PBX. Some will require you to enable local accounts or URI dialing. For help, find the manual or documentation for your SIP device/client.
Softphone Clients
These are some softphone clients that let you dial SIP URIs without a SIP account and are commonly used.
- MicroSIP
- A commonly used SIP client that can be used to dial SIP URIs.
- Before you can dial URIs without a SIP account, you will need to go to MicroSIP settings and check "Enable Local Account".
- Written for Windows, can be used on Unix-like systems with WineHQ.
Configuring a trunk in CUCM
You can configure WikiPhone as a trunk in CUCM so that you can reach a WikiPhone service by dialing a DN on your phones. Since WikiPhone does not require authentication or registration, this can be done without an external border element.
To configure WikiPhone as a trunk, go to Device -> Trunk and choose SIP as the trunk type. Name the trunk WikiPhone. Set your device pool, and set the SIP Trunk Security Profile as "Non Secure SIP Trunk Profile". And set the SIP profile to "Standard SIP Profile". Set the Destination Address to "telephones.wiki" or if you don't have DNS, you can use our static IPv4 which is "135.148.32.154". And then save the trunk and click reset.
Now you can go to Call Routing > Route/Hunt > Route Pattern and create a new pattern. Set the call pattern to what you want for the perticler service. And set Gateway/Route List to your WikiPhone trunk. Then under Called Party Transformations, enter the numeric number of the service you want this DN to route to (not the full URI). And click save. Repeat this step for every service you wanna be able to access.
Once you are done, you should now be able to dial the DN you configured to reach the particular service of your choice. If you cannot hear audio, make sure your codecs are setup correctly, and that calls are being routed properly over NAT. If your call is declined, ensure you used a vaild number, and that the IP/FQDN is correct.